Squirt Dual Nand PCB 512MB

Squirt DUAL NAND PCB 512 Megabyte. For PHAT consoles

1. On-board 16 Mbyte HYNIX NAND, part no. HY27UF084G2B
2. 10KOhm pull-up resistor that can be enabled with an ON-BOARD jumper (compatible with any CoolRunner chip)
3. Handy pads for wired installation
4. 2x ZIF 32 connectors to use the board with a SOLDERLESS NAND CLIP

Warning! On PHAT consoles, since the release of the new dashboards above 14699, RGH2.0 codes are mandatory. The SQUIRT DUAL NAND software is available for RGH2.0 only when using the QSB DUAL NAND PHAT, so only in this configuration can you use the SYNC button to switch NANDs. You can still install a physical switch to change NAND, as shown in the updated Squirt tutorials.