Squirt Dual Nand PCB 512MB

Squirt DUAL NAND PCB 512 Megabyte. For PHAT consoles

1. Nand HYNIX 16 Mbyte on board part no. HY27UF084G2B
2. 10KOhm pull up resistor that can be enabled with an on-board jumper (compatible with any cool runner chip)
3. Convenient pads for wired installation
4. 2x ZIF 32 connectors to use the board with NAND CLIP SOLDERLESS

Attention! In PHAT consoles after the release of new dashboards above 14699, the use of RGH2.0 codes is mandatory. The DUAL NAND software for SQUIRT is available for RGH2.0 only using the QSB DUAL NAND PHAT and therefore only in this configuration is it possible to use the SYNC button to switch the NAND. However, it is always possible to install a physical switch to change the NAND as per the updated squirt tutorials.